Leviton Light Switch Blinking Red

Your smartlockpro self test gfci is engineered to regularly conduct an internal test self test to confirm that protected power is available offering an added layer of.

Leviton light switch blinking red. Device failed to connect to its assigned wi fi network. Allows customized adjustments to maximize energy savings. To comply with t24 red led indicator light flashes when sensor detects motion to verify detection is active.

Green light indicates the device has passed the self test and is providing power. The product is being reset. Device is attempting to connect to its assigned wi fi network.

The led can either be flashing approximately three blinks per second blinking approximately one blink per second solidly lit or not lit. Once the led returns to solid purple the wall switch is ready to be set up again through the idevices connected app. Wall switch setup on ios 11 and later.

Leviton smartlockpro self test gfci devices introduced in 2015 feature a small led status indicator light to give you a convenient way to check the level of ground fault protection at a glance. Factory reset the decora smart wi fi device by pressing and holding the top paddle for 15 seconds until the led begins to flash red and amber then release the paddle. Time delay adjustment for delayed off time set tings of 30 seconds for walking test 10 minutes 20 minutes and 30 minutes.

Device is in enrollment mode. Wall switch setup on android.