Leviton Light Switch Pairing Mode

My smartthings app found it almost immediately after doing that.

Leviton light switch pairing mode. Enter programming mode by holding the top of the paddle for 7 seconds the locator led will turn amber. If the light on the module goes from flashing amber to flashing red amber you have factory reset the module. The three way switch is a variation of the standard single pole switch which controls a light only from one location.

I did have the instruction sheet from leviton but that only has instructions for resetting it not putting it into pairing mode. The info you posted from smartthings got me going in the right direction. When pairing your leviton devices press and hold the control button until the light begins flashing amber.

We would like to show you a description here but the site won t allow us. Just to reiterate to pair you push the top until the switch pops off. Led on when the load is on.

Then release the switch. The operation of the led can be changed. 2 the harmony hub extender is indeed compatible with the dzmx1 and will directly control it without any other devices.

The locator led is used to show the current state of the load. 1 you need to start pairing from the air gap position then push down and hold until it turns amber it will then be in pairing mode. How do i make my leviton switch discoverable.

When pairing your leviton devices press and hold the control button until the light begins flashing amber.