Leviton Light Switch Removal

Disconnect circuit conductors from existing single pole switch and remove old switch if applicable.

Leviton light switch removal. Remove pre cut insulation sleeves on each timer switch lead to expose bare wire strands. In this video i walk through the process of replacing a traditional toggle switch with a more modern leviton decora rocker arm switch. This warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation.

Insulate end of yellow lead. Check time delay settings and compare to how long the lights stay on. I am trying to replace a leviton nom 057 light switch with a dimmer switch.

Adjust the light level adjustment toward lighter counterclockwise depending on room conditions. If it isn t turn one at a time off and check the room for power by trying to turn a light switch on. Lights always stay on.

Page 2 leviton manufacturing co inc att. When i remove the old switch on the back of the switch i have a red and black wire connected to the two side terminals and another black connected to a pin in the center of the switch. Remove insulation from circuit conductors to expose 3 4 1 9 cm bare copper.

You mean you can remove. 2 there should be three wires coming out of the wall box. With aluminum wire use only devices marked co alr or cu al.

The junction box has two romex cables in and one out to the current light. The two in have each a black wire going into to the push in terminals of the switch and one black one connected to a side screw going to the light. 1 remove the wall plate using a flat head screwdriver then remove the old light switch from the wall box.